tag:blogger.com,1999:blog-2842908800693991284.post7368277803497189087..comments2023-06-02T02:27:47.189-07:00Comments on Loca for Crafts: Plarn PlansLoca4craftshttp://www.blogger.com/profile/08907806006703228554noreply@blogger.comBlogger1125tag:blogger.com,1999:blog-2842908800693991284.post-20020335593589528792009-07-17T10:34:07.780-07:002009-07-17T10:34:07.780-07:00I am not sure, but I would try a rotary cutter, an...I am not sure, but I would try a rotary cutter, and just make long strips, but not cut all the way to the end.. I am assuming they are squares or rectangles, so I would start at the right bottom and if I wanted 1/2" strips, I would start cutting 1/2" up from the bottom, go until 1/2" from the left edge and stop. Then 1/2 inch above that start from the left edge, go until 1/2" short of the right edge and stop. You get a sort of zigzag pattern, and you don't have to tie knots or fuse so many ends this way. You could also spiral around from the outside in..Anonymoushttps://www.blogger.com/profile/00697719280970403373noreply@blogger.com